Advertisement
32.9 Removing the Receptor Board Assembly
Prerequisite condition: The step explained in Subsection 3.21 must have been
completed.
1. Remove the screw mounting the receptor to the power supply unit.
Screw:
P/N1033122 (mounting torque:
2. Disconnect the cable from the connector (CN600) on the driver board block and
remove the receptor board assembly.
Caution:
When installing the receptor board assembly, align the hole on the board with the boss
on the power supply unit before tightening the screw.
Power
board
Figure
3-14
unit
=
Advertisement
