Setting The Frequency Step (7 Fm Am Step); Setting The Beep Volume (8 Beep); Setting The Microcomputer Clock Shift (9 Clock Type); Setting The Program Keys On The Microphone (10 Mic Program Key) - Yaesu FTM-100DR Operating Manual

Setup menu operations: 8 CONFIG

Setting the frequency step (7 FM AM STEP)

Using the knobs (DIAL/VOL) and keys, you can change the frequency step.
For details, see "Changing the frequency steps" on page 37.

Setting the beep volume (8 BEEP)

You can change the volume of the operation beep sound.
For details, see "Changing the beep volume" on page 45.

Setting the microcomputer clock shift (9 CLOCK TYPE)

You can set the transceiver microcomputer clock shift to change an internal spurious
signal that may be interfering with a particular receiver frequency. Select "A" for the
normal operation.
1
Press and hold
The Setup menu appears.
2
Rotate the DIAL to select [8 CONFIG], then press
.
3
Rotate the DIAL to select [9 CLOCK TYPE], then
press .
4
Rotate the DIAL to select [1 A] or [2 B].
1 A: Automatically switches the clock shift operation
between ON and OFF.
2 B: Always activates the clock shift operation.
Tip The default setting: 1 A
5
Press and hold
Sets the clock shift type and returns the display to the previously viewed screen.
Setting the program keys on the microphone
(10 MIC PROGRAM KEY)
Assign functions to each program key ([P1] to [P4]) on the supplied microphone (MH-
48).
1
Press and hold
The Setup menu appears.
2
Rotate the DIAL to select [8 CONFIG], then press
.
138
for over one second.
for over one second.
for over one second.