Scanning The Programmable Memories (Pms); Registering To The Programmable Memory Channels - Yaesu FTM-100DR Operating Manual

Searching for signals
4
Press , (
On the right side of the memory channel number
display blin s. his indicates the
he memory channels with this indicator are s ipped
during scanning.
Tips o unselect the memory channel press
o set other memory channels repeat steps
5
Press .
he display returns to the pre iously iewed screen.
memory channel number.

Scanning the programmable memories (PMS)

Usin the dedicated
requency ran e will be scanned.
e ister the desired requency ran e to the

Registering to the programmable memory channels

pairs U
channels.
e ister the lower limit o the desired scannin
"LP and the upper limit to the memory channel U
ne pair o
are handled as one
Example: Set up a PMS channel by registering a lower frequency of 433.200 MHz
and an upper frequency of 433.700 MHz to the P1 (LP1/UP1) memory
channel.
1
witch to
2
otate the
une in to the requency to set or the lower limit
Caution he requency entered as the lower limit
3
Press and hold
he
4
otate the
Tip name ta may also be assi ned to each memory
channel (
5
Press .
he display returns to the pre ious screen and shows the re istered requency and
memory channel number.
6
Press to switch to
68
appears on the upper side).
memory channels only the requencies within the speci ied
to U o requencies can be entered to the
memories with the same channel number
channel
mode.
tune to the desired lower limit scan requency.
or o er one second.
screen appears.
to select [LP1].
page 56).
mode.
state.
twice. turns o .
to .
memory channels in ad ance.
requency ran e to the memory channel
.
.
.
must be lower than the upper limit U
blin s on the le t side o the
memory
a number rom
.
to
.