System Memory Configuration; Install Memory; Upgrade Memory - Shuttle FT62 Manual

3.3 System Memory Configuration

The FT62 mainboard has two 184-pin DIMM slots that allow you to install from
32MB up to 2GB of system memory. Each 184-pin DIMM (Dual In-line Memory
Module) Slot can accommodate 64MB, 128MB, 256MB, 512MB, and 1GB of
PC1600,PC2100, PC2700 or PC3200 compliant 2.5V single (1 Bank) or
double (2 Bank) side 64-bit wide data path DDR SDRAM modules.

Install Memory:

Install memory in any or all of the banks. The combination shown as follows.
Density
64 Mbit
128 Mbit
256 Mbit
512 Mbit
1024 Mbit
Note: Maximum installed memory is 2GB.
N o t e : You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically.
You can check the total system memory value in the BIOS Standard
CMOS Setup menu.

Upgrade Memory:

You can easily upgrade the system memory by inserting additional DDR SDRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
Device Width Single/Double
4M x 16
8M x 8
4M x 32
8M x 16
16M x 8
8M x 32
16M x 16
32M x 8
32M x 16
64M x 8
64M x 16
128M x 8
- 39 -
184pin DDR DIMMs
SS / DS
SS / DS 64 / 128 MB
SS / DS
SS / DS 64 / 128 MB
SS / DS 128 / 256 MB
SS / DS 64 / 128 MB
SS / DS 128 / 256 MB
SS / DS 256 / 512 MB
SS / DS 256 / 512 MB
SS / DS 512 / 1024 MB
SS / DS 512 / 1024 MB
SS / DS 1024 / 2048 MB
32 / 64 MB
32 / 64 MB