Clear Cmos Setting (Jp1) - Shuttle FT62 Manual

F
Jumpers

Clear CMOS Setting (JP1)

A1
JP1 is used to clear CMOS data. Clearing CMOS will result in the permanently
erasing previous system configuration settings and the restoring original(factory-
set) system settings.
Step 1. Turn off the system power (PC-> Off).
Step 2. Remove DC-IN(12V) Power cable from DC-IN Power connector.
Step 3. Remove jumper cap from JP1 pins 1-2.
Step 4. Place the jumper cap on JP1 pin 2-3 for a few seconds.
Step 5. Return the jumper cap to pin 1-2.
Step 6. Please wait for 2 seconds.
Step 7. Plug DC-IN Power cable into DC-IN Power connector.
Step 8. Turn on the system power (PC-> On).
Pin 2-3 (Clear CMOS)
1
Pin 1-2 (Default)
1
Clear CMOS
1
JP1
- 27 -