Shuttle FT62 Manual page 63

IDE HDD Block Mode
Select Enabled for automatic detection of the optimal number of block
read/write per sector the drive can support.
Ø The Choice: Enabled or Disabled.
SB200 OnChip PCI Device
Option are in its sub-menu.
Press<Enter>to enter the sub-menu of detailed options.
Onboard AC97 Audio
This item allows you to control the onboard AC97 Audio.
Ø The Choice: Auto or Disabled.
SuperIO Device
Option are in its sub-menu.
Press<Enter>to enter the sub-menu of detailed options.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request ( IRQ )
for the onboard serial port1 ( COM1 ).
Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request ( IRQ )
for the onboard infrared port.
Ø The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
or Auto.
UART Mode Select
This field is available if the Onboard Serial Port 2 field is set to any option
but disabled. UART Mode Select enables you to select the infrared com-
munication protocol-Normal ( default ), IrDA, or ASKIR. IrDA is an infra-
red communication protocol with a maximum baud rate up to 115.2K
bps. ASKIR is Sharp's infrared communication protocol with a maximum
baud rate up to 57.6K bps.
Ø The choice: SCR, IrDA, or ASKIR.
UR2 Duplex Mode
This item is available when UART 2 mode is set to either ASKIR or IrDA.
This item enables you to determin the infrared function of the onboard
infrared chip. The options are Full and Half ( default ).
Full-duplex means that you can transmit and send information simulta-
neously. Half-duplex is the transmission of data in both directions, but
only one direction at a time.
Ø The choice: Full or Half.
- 59 -