System Memory Configuration - Shuttle FN95 User Manual

3.3 System Memory Configuration

The FN95 mainboard has two 184-pin DIMM slots that allow you to install
from 64MB up to 2GB of system memory. Each 184-pin DIMM (Dual In-line
Memory Module) Slot can accommodate 64MB, 128MB, 256MB, 512MB, and
1GB of PC2100, PC2700 or PC3200 compliant 2.6V single or double side 64-
bit wide data path DDR SDRAM modules.
Install Memory:
Install memory in any or all of the slots and in any combination shown as
follows.
Devices Used on DIMMs
64 M-bit (2M x8-bits x4 bnaks)
64 M-bit (1M x16-bits x4 bnaks)
128 M-bit (4M x8-bits x4 bnaks)
128 M-bit (2M x16-bits x4 bnaks)
256 M-bit (8M x8-bits x4 bnaks)
256 M-bit (4M x16-bits x4 bnaks)
512 M-bit (16M x8-bits x4 bnaks)
512 M-bit (8M x16-bits x4 bnaks)
1 G-bit (32M x8-bits x4 bnaks)
1 G-bit (16M x16-bits x4 bnaks)
Note: Total 2 DIMM capacities are up to 2GB max and 1GB per DIMM.
Memory Configuration:
64-Bit
64-Bit
128-Bit
128-Bit
Note: Please plug the DIMM1 first.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDR SDRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
Size Per CS
64 Mbyte
32 Mbyte
128 Mbyte
64 Mbyte
256 Mbyte
128 Mbyte
512 Mbyte
256 Mbyte
1 Gbyte
512 Mbyte
DIMM1 DIMM2
Single Side X
Double Side X
Single Side Single Side
Double Side Double Side
- 39 -