Table of Contents
Advertisement
3.3 System Memory Configuration
The MS52/MS52N & MS54/MS54N mainboard has two 184-pin DIMM slots
that allow you to install from 128MB up to 2GB of system memory.
Each 184-pin DIMM (Dual In-line Memory Module) Slot can accommodate ,
128MB, 256MB, 512MB, and 1GB of PC1600/PC2100/PC2700 compliant
2.5V single (1 Bank) or double (2 Bank) side 64-bit wide data path DDR
SDRAM modules.
For MS52 & MS52N with SiS651 Northbridge can support PC1600/PC2100/
PC2700 DDR SDRAM.
For MS54 & MS54N with SiS650GL Northbridge can support PC1600/
PC2100 DDR SDRAM.
Install Memory:
Install memory in any or all of the slots and in any combination shown as
follows.
DIMM
DIMM 1
DIMM 2
Note: Maximum installed memory is 2GB.
Note: You do not need to set any jumper to configure memory since the BIOS
utility can detect the system memory automatically. You can check the
total system memory value in the BIOS Standard CMOS Setup menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDR
SDRAM modules in available DIMM slots. The total system memory is
calculated by simply adding up the memory in all DIMM slots. After
upgrade, the new system memory value will automatically be computed and
displayed in the field " Standard CMOS Setup" of BIOS setup program.
Memory Modules
128MB, 256MB, 512MB, and 1GB 184-pin
2.5V DDR SDRAM DIMM
128MB, 256MB, 512MB, and 1GB 184-pin
2.5V DDR SDRAM DIMM
- 38 -
Module
Quantity
x 1
x 1
Advertisement
Table of Contents
