Save & Exit Setup; Exit Without Saving - Shuttle FT62 Manual

New Password Setting:
1. While pressing <Enter> to set a password, a dialog box appears to
2. Key in a new password. The password can not exceed eight charac-
3. System will request you to confirm the new password again.
4. When completed, new code takes effect.
No Password Setting:
If you want to disable the password, just press <Enter> as a password
input is requested.
If You Forget Password:
If you forget the password, the only way to access the system is to clear
the CMOS memory. Please refer to page 27 on clear CMOS setting.
@
Save & Exit Setup
Pressing <Enter> on this item asks for confirmation:
Pressing "Y" stores the selections made in the menus of CMOS - a
special section of memory that stays on after you turn your system off.
The next time you boot your computer, the BIOS configures your
system according to the Setup selections stored in CMOS. After saving
the values the system is restarted again.
@

Exit Without Saving

Pressing <Enter> on this item asks for confirmation:
This allows you to exit from Setup without storing in CMOS any
change. The previous selections remain in effect. This exits from the
Setup utility and restarts your computer.
ask you enter a password.
ters.
SAVE to CMOS and EXIT (Y/N)? Y
Quit Without Saving (Y/N)? N
- 69 -