System Memory Configuration; Install Memory; Upgrade Memory - Shuttle MT63 Manual

3.3 System Memory Configuration

The MT63 mainboard has two 184-pin DIMM slots that allow you to install
from 64MB up to 2GB of system memory. Each 184-pin DIMM (Dual In-line
Memory Module) Slot can accommodate 64MB, 128MB, 256MB, 512MB,
and 1GB of PC1600/PC2100/PC2700/PC3200 compliant 2.5V single (1 Bank)
or double (2 Bank) side 64-bit wide data path DDR SDRAM modules.

Install Memory:

Install memory in any or all of the slots and in any combination shown as
follows.
DIMM Slot
DIMM 2 64Mb, 128Mb, 256Mb ,512Mb and 1Gb (x4 x8 x16) 184-pin 2.5V DDR SDRAM DIMM
DIMM 4 64Mb, 128Mb, 256Mb ,512Mb and 1Gb (x4 x8 x16) 184-pin 2.5V DDR SDRAM DIMM
The PC3200 module support 4 Bank shown as follows:
N o t e : You do not need to set any jumper to configure memory since the BIOS utility
can detect the system memory automatically. You can check the total system
memory value in the BIOS Standard CMOS Setup menu.

Upgrade Memory:

You can easily upgrade the system memory by inserting additional DDR SDRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new system
memory value will automatically be computed and displayed in the field " Stan-
dard CMOS Setup" of BIOS setup program.
DDR SDRAM
Memory DIMM 2
Single side
Double side
PC3200
Module
Double side
Double side
- 39 -
Memory Modules
DIMM 4
Single side 2 BANK
Empty 2 BANK
3 BANK
Single side
Double side 4 BANK
TOTAL
Module
Quantity
X 1
X 1