Shuttle FT62 Manual page 66

Video Off Option
When enabled, this feature allows the VGA adapter to operate in a
power-saving mode.
Always On
Suspend --> Off
Ø The choice:
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
Blank Screen
DPMS Support
Ø The choice: V/H SYNC+Blank, DPMS Support, or Blank Screen.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Soft-Off by PWR-BTTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay4
Sec. then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø The choice: Instant-Off or Delay 4 Sec.
Wake Up by PCI Card
This item Enabled/Disabled PCI Power Management Event to Wake Up
system. Set PCIPME wakeup systen from S1/S3/S4/S5.
Ø The choice: Enabled or Disabled.
Wake Up by Ring
This item determine the system will resume by activating of modem ring.
Set Moden Ring wakeup systen from S1/S3/S4/S5.
Ø The choice: Enabled or Disabled.
Monitor will remain on during the power-
saving mode.
Monitor is blanked when the system enters
into the suspend mode.
Always On or Suspend ->Off.
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
This option only writes blanks to the video
buffer.
Initial display power management signaling.
- 62 -