Table of Contents
Advertisement
3.3 System Memory Configuration
The AV11 mainboard has three 168-pin DIMM sockets that allow you to
install from 16MB up to 768MB of system memory with PC66/100/133
SDRAM (Synchronous DRAM). Each DIMM (Dual In-line Memory Module)
socket can accommodate 16MB, 32MB, 64MB, 128MB, and 256MB 3.3V
single or double side SDRAM modules. DIMM sockets are arranged in two
banks, each memory bank made of one socket and providing a 64 bit wide
data path.
The AV11 mainboard supports data integrity algorithms including EC (Error
Checking) and ECC (Error Checking and Correction) in the memory array.
In EC mode, single and multiple bit error detection is provided. In ECC
mode, when the memory is being read from DRAM, the AV11 provides
both error checking and correction of the data.
Install Memory:
Install memory in any or all of the banks and in any combination, as follows.
DIMM
Socket
DIMM 4
DIMM 5
DIMM 6
Note:
You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically. You can
check the total system memory value in the BIOS Standard CMOS
Setup menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional SDRAM
modules in available DIMM banks. The total system memory is calculated
by simply adding up the memory in all DIMM banks. After upgrade, the
new system memory value will automatically be computed and displayed
by the BIOS Standard CMOS Setup menu.
Memory Modules
16MB, 32MB, 64MB, 128MB, 256MB 168-pin
3.3V SDRAM DIMM
16MB, 32MB, 64MB, 128MB, 256MB 168-pin
3.3V SDRAM DIMM
16MB, 32MB, 64MB, 128MB, 256MB 168-pin
3.3V SDRAM DIMM
- 35 -
Module
Quantity
x 1
x 1
x 1
Advertisement
Table of Contents
