Table of Contents
Advertisement
3.3 System Memory Configuration
The MV43P/MV43PN mainboard has two 184-pin and two 168-pin DIMM
slots that allow you to install from 64MB up to 2GB of system memory.
Each 184-pin DIMM (Dual In-line Memory Module) slot can accommodate
64MB, 128MB, 256MB, 512MB, and 1GB of PC1600/PC2100 compliant
2.5V single or double side 64-bit wide data path DDR SDRAM modules.
Each 168-pin DIMM (Dual In-line Memory Module) Slot can accommodate
64MB, 128MB, 256MB, 512MB, and 1GB of PC100/PC133 compliant 3.3V
single or double side 64-bit wide data path SDRAM modules.
Install Memory:
Install memory in any or all of the slots and in any combination shown as
follows.
SDR SDRAM
DIMM Slot
DIMM 1
DIMM 2
DDR SDRAM
DIMM Slot
DR
D
DR
D
Important: You can choose 168-pin SDR SDRAM or 184-pin DDR
Note: You need to set jumpers to configure memory by jumper J2A/B/C/D &
J3A/B/C/D & JP1. Please refer to the details page 29. You can check
the total system memory value in the BIOS Standard CMOS Setup
menu.
Upgrade Memory:
You can easily upgrade the system memory by inserting additional DRAM
modules in available DIMM slots. The total system memory is calculated by
simply adding up the memory in all DIMM slots. After upgrade, the new
system memory value will automatically be computed and displayed in the
field " Standard CMOS Setup" of BIOS setup program.
Memory Modules
B, 512MB and
64MB, 128MB, 256M
pin 3.3V SDR SDRAM DIMM
B, 512MB and
64MB, 128MB, 256M
pin 3.3V SDR SDRAM DIMM
Memory Modules
B, 512MB and
64MB, 128MB, 256M
1
2.5
D
184-pin
V
DR SDRAM DIMM
B, 512MB and
64MB, 128MB, 256M
2
2.5
D
184-pin
V
DR SDRAM DIMM
SDRAM to boot, but the system doesn't start if you use
both of them at the same time!
- 41 -
Module
Quantity
1GB 168-
x 1
1GB 168-
x 1
Module
Quantity
1GB
x 1
1GB
x 1
Advertisement
Table of Contents
