Table of Contents
Advertisement
3.3 System Memory Configuration
The MK35/MK35N mainboard has two 184-pin DIMM banks that allow you
to install from 128MB up to 2GB of system memory.
Each 184-pin DIMM (Dual In-line Memory Module) bank can accommodate
128MB, 256MB, 512MB, and 1GB of PC1600/PC2100 compliant 2.5V
single or double side 64-bit wide data path DDR SDRAM modules.
1. Install Memory:
Install memory in any or all of the banks. The combination shown as follows.
DIMM
Slot
DIMM 1
DIMM 2
Maximum installed memory is 2GB.
Note:
You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically. You can
check the total system memory value in the BIOS Standard CMOS
Setup menu.
2. Upgrade Memory:
You can easily upgrade the system memory by inserting additional DDR
SDRAM modules in available DIMM banks. The total system memory is
calculated by simply adding up the memory in all DIMM banks After up-
grade, the new system memory value will automatically be computed and
displayed in the field "Standard CMOS Setup" of BIOS setup program.
Memory Modules
128MB, 256MB, 512M and 1GB
DDR SDRAM DIMM
128MB, 256MB, 512M and 1GB
DDR SDRAM DIMM
- 37 -
, 184
2.5
-pin
V
, 184
2.5
-pin
V
Module
Quantity
x 1
x 1
Advertisement
Table of Contents
