Connecting A Poe Adapter; Verifying The Installation - H3C MSR3610-I Series Installation Manual

Connecting a PoE adapter

IMPORTANT:
• A PoE adapter is used only for PoE output. Before connecting a PoE adapter to the device, make
sure the device is connected to an AC power source and is operating correctly. The device
cannot operate correctly with only a PoE adapter connected to it.
• Only the MSR3610-I-IG and MSR3610-IE-IG gateways support a PoE adapter.
To connect a PoE adapter:
1. Insert the DC power connector at one end of the PoE adapter into the device.
2. Connect the other end of the PoE adapter to an AC power source.
Figure2-17 Connecting a PoE adapter

Verifying the installation

Verify the following items before you power on the device:
•
There is enough space around the device for heat dissipation.
•
The interface modules and USB devices are installed correctly.
•
The device, rack, and power source are reliably grounded.
•
The power source is as required by the device.
•
The device is connected correctly to the configuration terminal and other devices. The
configuration terminal is configured correctly and has been started.
18