Connecting An Ac Power Cable - H3C SecPath M9000 Series Installation, Quick Start
Multi service security gateway
Hide thumbs
Also See for SecPath M9000 Series:
- Manual (90 pages) ,
- Quick manual (4 pages) ,
- Compliance and safety manual (57 pages)
Table of Contents
Advertisement
Figure 10 Installing a power module in a vertical slot (on an M9010)
Figure 11 Installing a power module in a horizontal slot
Connecting an AC power cable
WARNING!
Before you connect the power cable, make sure the circuit breaker on the power cable is switched off.
To connect the power cable:
1.
Plug the power cable into the power receptacle of the power module.
2.
Use a cable tie to secure the power cable to the cable management bracket.
3.
Plug the other end of the power cable to the AC power receptacle of the power source.
9
Advertisement
Table of Contents
