Table of Contents
Advertisement
3.
Unpack the power supply and verify that the power supply model is correct.
4.
Correctly orient the power supply with the power supply slot. Grasp the handle of the power
supply with one hand and support its bottom with the other, and slide the power supply slowly
along the guide rails into the slot.
The slot is foolproof. If you cannot insert the power supply into the slot, re-orient the power
supply rather than use excessive force to push it in.
Figure8-8 Installing a power supply
9
Connecting power cords
CAUTION:
• Before connecting a power cord, make sure the device is reliably grounded.
• Make sure each power cord has a separate circuit breaker. Before connecting a power cord,
turn off the circuit breaker for it.
• Use the power cord provided with a power supply to connect power for it.
Connecting an AC power cord
1.
Wear an ESD wrist strap. Make sure the wrist strap makes good skin contact and is reliably
grounded.
2.
Insert the female connector of the power cord into the AC power receptacle on the power
supply.
3.
Use a cable tie to secure the power cord to the handle of the power supply.
4.
Connect the other end of the power cord to an AC power source.
24
Advertisement
Table of Contents
