Preparing For Installation; Safety Recommendations; Safety Symbols; General Safety Recommendations - H3C MSR3610-I Series Installation Manual

1

Preparing for installation

This document applies to the following models:
•
MSR3610-I-XS
•
MSR3610-IE-XS
•
MSR3610-I-DP
•
MSR3610-IE-DP
•
MSR3610-IE-ES
•
MSR3610-IE-EAD
•
MSR3610-I-IG
•
MSR3610-IE-IG

Safety recommendations

Safety symbols

When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.

General safety recommendations

•
Keep the device and installation tools away from walk areas.
•
Place the device in a dry and flat location and make sure anti-slip measures are in place.
•
Remove all external interface cables and power cords before moving the device.

Electricity safety

•
Locate the power-off switch in the equipment room before installation. Shut off the power
immediately if an accident occurs. Disconnect the power cord from the device if necessary.
•
Make sure the device is reliably grounded.
•
Connect the interface cables correctly.
•
When you power off the device that has two power inputs, make sure you remove both power
cords.
•
Always make sure the device is completely powered off during the installation or replacement
procedure.
1