Table of Contents
Advertisement
Figure 2-22 Removing a filler panel (M9000-AI-E16 gateway)
2.
Correctly orient the power supply.
3.
Align the power supply with the power supply slot. Then slide the power supply along the guide
rails into the slot until the latch locks the power supply in place.
Figure 2-23 Installing a power supply (M9000-AI-E16 gateway)
Connecting a DC power cord
WARNING!
Before you connect a DC power cord, make sure the circuit breakers for both of the positive and
negative power input wires are turned off.
23
Advertisement
Table of Contents
