Basic Setup With The Tof Tool - Endress+Hauser Fieldbus Levelflex M FMP43 Operating Instructions Manual

Levelflex M FMP43 with FOUNDATION Fieldbus
⇒
ENDRESS + HAUSER
–
+ E
!
Endress+Hauser
Exiting the navigation
F
• Press again to run through the different modes of the envelope curve navigation.
O S
• Press and to exit the navigation. The set increases and shifts are retained. Only when you
reactivate the "recording curve"(0E2) function does the Levelflex use the standard display
again.
⇓
6.8

Basic setup with the ToF Tool

To carry out the basic setup with the ToF Tool operating program, proceed as follows:
• Start the ToF Tool operating program on the PC and establish a connection
• Select the "basic setup" function group in the navigation bar
The following appears on the screen:
Basic setup step 1/6:
• Status image
• The TAG number can be entered.
Note!
• Each parameter that is changed must be confirmed with the RETURN key!
• The "Next" button takes you to the next screen:
After 3 s, the following message appears
Commissioning
L00-FMP4xxxx-20-00-00-en-001
71