Endress+Hauser Fieldbus Levelflex M FMP43 Operating Instructions Manual page 41

Levelflex M FMP43 with FOUNDATION Fieldbus
Endress+Hauser
5.5.2 Hardware settings
A DIP-switch in the connection compartment of the instrument allows the write protection and
simulation functions to be set via hardware.
• If "SIM" is switched off, the simulation function is not accesible in the configuration tool.
• If "WP" is switched on, parameter access is disabled
EN EN
MIC MIC DR DR ES ES
Orde Orde r Cod r Cod RO RO S+ S+ HA HA
Ser.- Ser.- No.: No.: e: e: PIL PIL OT OT US US
II II ER ER
Mes Mea Mes Mea sber sber
surin surin g rang eich g rang eich
U 16... U 16... e e max max
4...2 4...2 36 36 V DC V DC . 20 . 20 m m
0 mA 0 mA IP IP
65 65
T T >70° >70° A A
C : C :
t >85° t >85° C C
Device identification
FOUNDATION Fieldbus identifies the device by its identification code and automatically allocates
an appropriate field address. There is no separate hardware switch for this purpose.
5.5.3 Network configuration
During the configuration of the FOUNDATION Fieldbus network the device description (DD) of the
Levelflex M must be downloaded into the directory foreseen for it.
• Start the interface configuration tool.
• Configure the interface.
• Call the DD download routine.
• Download the device descriptions (.ffo and .sym files) to the directory offered.
• When the configuration is complete, close the tool and the FOUNDATION Fieldbus stack (if
open).
The Levelflex M device descriptions can be ordered direct from Endress+Hauser or downloaded
from our website "www.endress.com". They contain all data necessary to operate
Endress+Hauser FOUNDATION Fieldbus devices.
on
off
SIM WP
default settings:
write protection OFF
simulation ON (i.e. simulation is
allowed in the configuration tool)
write protection
on
off
SIM WP
simulation
L00-FMxxxxxx-19-00-00-en-002
Operation
41