Operation Of The Device; How To Use The Touch-Screen; Touch-Screen Calibration - Innomed Medical HeartScreen 80G-L1 User Manual

HS80G-L1 Users' Manual

Operation of the device

6.
HeartScreen 80G-L1 device can be operated by device keys or by touching the respective
area of the screen.
6.1.

How to use the touch-screen

By touching the screen, we can give instructions to the device. The information referring to
the instruction appears on the display (e.g. a key or a definitely marked area of the screen).
The touch-screen can be handled by the finger tips or by the nails, or by a pencil shaped
plastic instrument, made for this purpose.
Warning!
Do not use sharp or pointed instruments, made of too hard material, because they can cause
scratching, damage on the screen. You are also recommended not to use biro, as the
painting, flowing out of it might get stuck to the screen.
The device is delivered from the factory with calibrated touch-screen, meaning that the
surface to be touched and the picture underneath are overlapping each other. In case, due to
some errors calibration is terminated, touch-screen operation will not work properly, saying
that by touching the marked surface (key displayed on the screen) the instruction is not
executed. In such case, the touch-screen requires a re-calibration, which is a simple process.

6.1.1. Touch-screen calibration

Look for any instrument which made of a not too hard material, e.g. a pencil or a thin plastic
stick. Switch on the device with the (1) power on key. Innomed logo will appear on the
display for a few seconds.
Touch the screen, until the logo is still visible. This makes the logo disappear, the display will
turn into monochrome, and a cross symbol appears on it. Touch the intersection of the cross
by the plastic stick. Then another cross symbol appears, touch the intersection of this cross as
well. Then a third cross symbol appears, touch it as well with the plastic stick. After this, the
display color changes, a zone of different color appears on the lower side of the display, and
again another cross symbol appears, which should be touched. As a result of this touch a fifth
cross symbol appears. When its intersection point is touched, the device turns off followed by
a sound signal, the calibration was successful.
16/61 R-7317-2-B