Table of Contents
Advertisement
Manual for ZBL-U5 series of Ultrasonic Detector
surface.
9.
Design Strength
The design strength grade of the object concrete to be tested may
be chosen within the value range from C10 to C100.
5.2.2 Advanced parameter
Press Advanced button in parameter setup interface to pop up
dialogue box as shown in Figure 5.4. This dialogue box includes two
property pages of General parameter and Calculation parameter.
After all parameters being set, press OK button to save setup
parameters, press Cancel button for not.
Press Reset button in advanced parameter setup interface to pop
up dialogue box inquiring "Whether restore parameter to factory
setting?"; press Yes button to restore all parameters to factory setting
and press No for not.
Note: If tested data exist, Reset button is invalid.
79
Advertisement
Table of Contents
