Table of Contents
Advertisement
Manual for ZBL-U5 series of Ultrasonic Detector
and the Search button again turns to the Exit button, and the data is
saved to the disk automatically.
7.3.3 Retest
Retest refers to testing the part or all of the tested data once again.
Please refer to Section 3.7 for details. New test data will cover the
previous data automatically in retest.
7.3.4
Test the next crack
After testing a crack, you must first create a new crack if testing
the next crack: Press the New crack button at the main interface to
pop out the crack number input box. The default is the last crack
number plus 1 and users are allowed to modify; the crack number is
not allowed to exceed 10 characters; the default crack number: LF-1,
LF-2.
Note: If the test of the test points on the current crack
is not completed, exit is allowed; the follow-up test or retest can
be achieved after reopening the file.
7.3.5
Test the next object
After testing an object, a new object shall be created before
moving to the next (press New button behind the Component name in
the parameter setup dialog box).
Before creating a new object, check whether the current object
data has been modified but not saved and prompt to save it. When
creating a new object, eliminate the current object data to maintain the
last parameter setting. (for example the starting point spacing and step
spacing).
108
Advertisement
Table of Contents
