Static Waveform Operation - Novatest ZBL-U5 Series Instruction Manual

Manual for ZBL-U5 series of Ultrasonic Detector
Press Search button for automatic sampling and searching the
head wave of current waveform.
4） Adjustment of base line
Press 【 】 or 【 】 buttons to adjust base line position upward
or downward;
5） Adjustment of noise range width
In dynamic sampling, press the bottom right of the single-channel
waveform range, operation panel as shown in Figure 3.5 will pop up
under the waveform. Press Baseline ↑and Basline ↓ buttons to
increase or decrease threshold value for determining head wave;
Figure 3.5 Operation panel for dynamic waveform
6）Close operation panel
Press any areas outside of single-channel waveform range to
close operation panel.

3.5.3 Static waveform operation

In the state of static waveform, press a certain waveform in
single-channel waveform range to use this channel as current channel,
one transverse cursor and one vertical cursor will appear in waveform
range, and operation panel as shown in Figure 3.6 will pop up under
current waveform.
Figure 3.6 Operation panel for static waveform
32