Table of Contents
Advertisement
Manual for ZBL-U5 series of Ultrasonic Detector
6.3.4 Test next object
After completing of test on one object, if next object is to be
tested, to test on next object, it must chose new object option: press
the New button behind the Component Name in the parameter setup
dialogue box
Prior to creating the object, check if the current data of the object
is modified but unsaved, and prompted to save. In creating object, the
data of the current object will be eliminated and all relevant
parameters will be reset;.
6.4
Ultrasonic Data List Area
The sequence number, spacing test，acoustic parameters for each
test point of current object are displayed in the Ultrasonic data
list area. As shown in Figure 6.5, the suspicious data will be
distinguished by shading of different color: if the acoustic
velocity is unlike at some point, the value of wave speed will be
displayed in red shading; If the amplitude of wave is suspicious,
it will be displayed in grey.
In the Ultrasonic data list area, press the data row to display them
Figure 6.5 Ultrasonic Data List
97
Advertisement
Table of Contents
