Table of Contents
Advertisement
Manual for ZBL-U5 series of Ultrasonic Detector
when button color is grey, it means this function is invalid in
such condition.
2） Waveform area: it is used to display the waveform and
acoustic parameter of current test point; please refer to Section
3.4 for details. Press any part in the waveform area, one
transverse cursor and one vertical cursor will appear, and
parameters such as acoustic time and amplitude will display
on the bottom of the waveform area.
3） Data list area: it is used to display the ultrasonic data of each
test point (acoustic time, wave speed, etc.);press the spacing
test cell in the data list area to pop up the modify interface of
spacing test, average rebound and carbonization depth to
modify the corresponding data.
4） Schematic graph area: it is used to display general parameter
such as the name of the object, spacing test and test method.
The conversion average strength value, standard deviation,
minimum value and deductive value of the current object
calculated as per the appropriate regulation will be shown
under the separator.
5.2 Parameter setup
Press Setting button in main interface of strength test to pop up
dialogue box as shown in Figure 5.2. Press Advanced button to enter
into the interface of advanced parameter setup and more parameter
setup is available. Default of each parameter is the value setup at last
time.
After have set all parameters, press OK button to validate all
settings, writing the setup value of parameters into the initialization
file and return to main interface; press Cancel button to invalidate all
75
Advertisement
Table of Contents
