Retest - Novatest ZBL-U5 Series Instruction Manual

Manual for ZBL-U5 series of Ultrasonic Detector

3.7 Retest

If need to retest the tested point, select the point which needs to
be retested in data list area, press Retest button to pop up prompt
box as shown in Figure 3.9a. After have coupled transducer with the
first point to be tested according to the prompt message, press OK
button to enter into retest mode, retest the points one by one and
save results until cancel retest mode or all points have been retested.
Retest button flashing in retesting samples means retest is in
progress.
If need to cancel retest, repress Retest button when stop
sampling in waveform, which means static waveform, prompt box as
shown in Figure 3.9b will pop up, press OK button to cancel retest
mode.
Note: This function is only applicable to software for
strength test, defect test and crack test;
a) Start retest
Figure 3.9 Dialogue box of retest
36
b) Finish retest