Defects Schematic Graph Area - Novatest ZBL-U5 Series Instruction Manual

Manual for ZBL-U5 series of Ultrasonic Detector
in yellow, the waveform in the Waveform area will change into that of
the test point, while the location of the test point will be displayed in
the Defects schematic graph area.
In the Ultrasonic data list area, certain spacing test, instead of
other values that are obtained by calculation, can be modified in the
table directly. Press the area where the spacing test data cell to be
modified is and pop up the digital soft keyboard to enter a new value.
Automatic calculation will be restarted after the data is modified.
The following operations can be also conducted in the Ultrasonic
data list area：
1） In the data list area, sliding up or down can lead to page up
or down；
2） When pressing certain row of data, the current waveform of
test point will be displayed in the waveform area, while the
current location of test point will be displayed in defects
schematic graph area.
6.5

Defects Schematic Graph Area

The Defects schematic graph area is located in the right side of
the main interface, displaying the layout of test point for current
object in grid. Each node of the grid stands for one test point,
which is shown in red dot after being tested.
After completion of testing, the suspicious test points will be
calculated and judged automatically as per the Technical
specification for inspection of Concreter defects by ultrasonic
methods （CECS21） ,and then the distribution graph of abnormal
test points with acoustic time, amplitude and frequency will be
displayed in different symbols, as shown in Figure 6.6
figure, means abnormal acoustic time，
98
In the
means abnormal