Manual for ZBL-U5 series of Ultrasonic Detector
4.3 Data collection
4.3.1 Start sampling
After have set parameters, press OK button to return to main
interface. Place all transducers at proper position, click Profile button
to choose the profile to be tested and press Sample button to
automatically Start continuous sampling.
After have adjusted the waveform of first test point in all profiles,
press Save and dialogue box of "Test pile length setup" (as shown in
Figure 4.9) will pop up to prompt user to input the position of first test
point (height value). This value could be obtained through depth mark
on signal wire of transducer.
Figure 4.9 Test pile length setup
61