Synchronize Time; Set Dst - HIKVISION iDS-TCD403-BI User Manual

Network Traffic Camera (for Traffic Flow Camera) User Manual
3. Click OK.

10.6 Synchronize Time

Synchronize the device time when it is inconsistent with the actual time.
Steps
1. Go to Configuration → Device Configuration → System → Time Settings .
2. Select Time Zone.
3. Select Time Sync. Mode.
NTP Time Sync.
Select it to synchronize the device time with that of the NTP server. Set Server Address, NTP
Port, and Interval. Click NTP Test to test if the connection between the device and the server
is normal.
Manual Time Sync.
Select it to synchronize the device time with that of the computer. Set time manually, or
check Sync. with computer time.
SDK
If the remote host has been set for the device, select it to synchronize time via the remote
host.
ONVIF
Select it to synchronize time via the third-party device.
No
Select it to disable time synchronization.
All
Select it, and you can select any mode above.
Note
The time synchronization modes vary with different models. The actual device prevails.
4. Click Save.

10.7 Set DST

If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → Device Configuration → System → DST .
2. Check Enable DST.
3. Set Start Time, End Time, and DST Bias.
42