HIKVISION iDS-TCD403-BI User Manual page 6

Network Traffic Camera (for Traffic Flow Camera) User Manual
Regulatory Information
This is a class A product and may cause radio interference in which case the user may be required
to take adequate measures.
Laws and Regulations
Use of the product must be in strict compliance with the local laws and regulations. Please shut
down the device in prohibited area.
Power Supply
• Use of the product must be in strict compliance with the local electrical safety regulations.
• Use the power adapter provided by qualified manufacturer. Refer to the product specification for
detailed power requirements.
• It is recommended to provide independent power adapter for each device as adapter overload
may cause over-heating or a fire hazard.
• Make sure that the power has been disconnected before you wire, install, or disassemble the
device in the authorized way according to the description in the manual.
• To avoid electric shock, DO NOT directly touch exposed contacts and components once the
device is powered up.
• DO NOT use damaged power supply devices (e.g., cable, power adapter, etc.) to avoid electric
shock, fire hazard, and explosion.
• DO NOT directly cut the power supply to shut down the device. Please shut down the device
normally and then unplug the power cord to avoid data loss.
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• Make sure the power supply has been disconnected if the power adapter is idle.
• Connect to earth before connecting to the power supply.
Transportation, Use, and Storage
• To avoid heat accumulation, good ventilation is required for a proper operating environment.
• Store the device in dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating
source environment.
• Avoid fire, water, and explosive environment when using the device.
• Install the device in such a way that lightning strikes can be avoided. Provide a surge suppressor
at the inlet opening of the equipment under special conditions such as the mountain top, iron
tower, and forest.
• Keep the device away from magnetic interference.
• Avoid device installation on vibratory surfaces or places. Failure to comply with this may cause
device damage.
• DO NOT touch the heat dissipation component to avoid burns.
Safety Instruction
v