Chapter 6 Network Configuration; Set Ip Address - HIKVISION iDS-TCD403-BI User Manual

Network Traffic Camera (for Traffic Flow Camera) User Manual

Chapter 6 Network Configuration

6.1 Set IP Address

IP address must be properly configured before you operate the device over network. IPv4 and IPv6
are both supported. Both versions can be configured simultaneously without conflicting to each
other.
Go to Configuration → Device Configuration → System → Network Interface Parameters .
NIC Type
Select a NIC (Network Interface Card) type according to your network condition.
IPv4
Two IPv4 modes are available.
DHCP
The device automatically gets the IPv4 parameters from the network if you check DHCP. The
device IP address is changed after enabling the function. You can use SADP to get the device IP
address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Configuration Protocol).
Manual
Figure 6-1 Set IP Address
27