Reftek 130-SMHR/9 User Manual page 4

Rev A
Follow these steps to update the firmware of a 130 DAS:
1. Unzip the 'main.s3' file from the downloaded zip file of the most recently released firmware.
2. Copy the desired firmware image to the root of the Compact Flash as 'main.s3' using a PC with a
Compact Flash reader or ftp into the 130 DAS, with a Compact Flash installed, in binary mode.
3. With the Compact Flash with the main.s3 image installed in the 130 DAS, issue a reset command.
(a) If you are at the 130 DAS:
1. Physically disconnect and reconnect power to the unit.
2. Observe the LCD for the following messages:
READING DISK DO NOT DISTURB
WRITING FLASH DO NOT DISTURB
3. The 130 DAS resets and returns to normal messaging.
(b) If you are remotely connected to a 130 DAS via telemetry mode:
1. If you are connecting remotely by a TCP connection:
a. First connect
b. Discover the unit
c. Acquire status
2. Issue a reset command from the Status screen.
3.
Delete the unit from the Station List screen.
4. Wait at least 5 minutes.
5. At the Connections screen (reconnect id using a TCP connection) issue a Station Discovery again to
discover the 130 DAS station.
Note: DO NOT DISTURB THE UNIT until the start-up LCD message reappears.
iv
REF TEK 130-SMHR/9 Users Guide
98060-00-UG
5/6/2021
Reftek Systems Inc.