Icom iF4261DT Operating Manual page 84

Previous view
7
NXDN™ OPERATION
Transmitting a call
D Transmitting a Revive call (Continued)
<Key operation>
Using [Digital Button]:
1. Push [Digital Button] to enter the Application
Selection mode.
• The current call type is briefly displayed, then "VOICE"
is displayed.
LTo change the call type, see page 7-3.
2. Push [CH Up] or [CH Down] to select "REVIVE,"
then push [Digital Button].
Portable
REVIVE
MENU DIGI ZONE SET DIGI
Mobile
R E V I V E
• Enters the Destination ID Selection mode.
3. Push [CH Up] or [CH Down] to select the
destination ID.
Portable
REVIVE
Station1
MENU DIGI ZONE SET DIGI
Mobile
R E V I V E
S t a t i o n 1
4. Push [PTT] to transmit the Revive command.
• "REV TX" is displayed while transmitting.
Innormation
L
• When the call type is "Talkgroup,"
disabled.
• "REV ACK" is displayed after receiving an
acknowledgment from the target station.
The target station is revived.
• "REV FAIL" is displayed if the target (stunned) station
does not send back an acknowledgement.
[P1](TX) or [P2] is
7-29
<Key operation>
Using [Individual]:
1. Push [Individual] to enter the Application Selection
mode.
• The current call type is briefly displayed, then "VOICE"
is displayed.
LTo change the call type, see page 7-3.
2. Push [CH Up] or [CH Down] to select "REVIVE,"
then push [Individual].
Portable
REVIVE
MENU DIGI ZONE SET INDV
Mobile
R E V I V E
• Enters the Destination ID Selection mode.
3. Push [CH Up] or [CH Down] to select the
destination ID.
Portable
REVIVE
Station1
MENU DIGI ZONE SET INDV
Mobile
R E V I V E
S t a t i o n 1
4. Push [PTT] to transmit the Revive command.
• "REV TX" is displayed while transmitting.
Innormation
L
• When the call type is "Talkgroup,"
disabled.
• "REV ACK" is displayed after receiving an
acknowledgment from the target station.
The target station is revived.
• "REV FAIL" is displayed if the target (stunned) station
does not send back an acknowledgement.
[P1](TX) or [P2] is