Icom iF4261DT Operating Manual page 66

Previous view
7
NXDN™ OPERATION
Transmitting a call
D Transmitting a Status message (Continued)
Using [Individual] or [Talkgroup]:
1. Push [Individual] or [Talkgroup] to enter the
Application Selection mode.
• "INDIVIDUAL" or "TALKGROUP" is briefly displayed,
then "VOICE" is displayed.
2. Push [CH Up] or [CH Down] to select "STATUS,"
then push [Individual] or [Talkgroup].
Portable
STATUS
MENU TGID ZONE SET TGID
Mobile
S T A T U S
• Enters the Status Message Selection mode.
3. Push [CH Up] or [CH Down] to select a status
message, then push [Individual] or [Talkgroup].
Portable
STATUS
TX Status 01
MENU TGID ZONE SET TGID
Mobile
S T A T U S
T X S t a t u s
• Enters the Destination ID Selection mode.
4. Push [CH Up] or [CH Down] to select the
destination ID.
Portable
STATUS
TG1
MENU TGID ZONE SET TGID
Mobile
S T A T U S
T G 1
0 1
7-11
5. Push [PTT] to transmit the status message to the
selected station or Talkgroup.
• "STAT OK" is displayed after receiving an
acknowledgement from the target station.
• "STA FAIL" is displayed if the target station does not
send back an acknowledgement.
Using [Status]:
1. Push [Status] to enter the Status Message
Selection mode.
2. Push [CH Up] or [CH Down] to select a status
message.
3. Hold down [Status] for 1 second to transmit
the status message to the last called station or
Talkgroup.
• "STAT OK" is displayed after receiving an
acknowledgement from the target station.
• "STA FAIL" is displayed if the target station does not
send back an acknowledgement.