Table of Contents
Advertisement
Turning the Stamp Feature ON/OFF
If you have turned the TX STAMP setting ON, documents will be
stamped according to the above setting. If you have not turned on the
TX STAMP feature but you still want to occasionally stamp documents
you scan for sending, or if you have turned on the TX STAMP feature but
you want to turn it off occasionally, follow the procedure below.
1. Set the document on the fax. (➞6-3)
2. Open all three of the One-touch Speed Dialing panels and press
Stamp(Option)
12-10
Other Special Features
TX Stamp Setup Summary
The default settings, shown in bold, remain in effect unless you
change them.
ON Turns on the stamp feature. After you set this switch ON,
documents will be stamped according to the following
settings. If you do not want to stamp temporarily, you can
use the STAMP button to turn the stamp feature off.
STAMP ACTION
DIRECT &
MEMORY TX
DIRECT TX
OFF Turns off stamping documents scanned for sending.
However, before you scan a document, you can still turn on
the stamp feature for a document you want to stamp with
button.
Stamp
Set the document resolution, contrast, and document type. (➞6-4)
You can also select a sender's name with the
(➞6-6)
.
Stamp
TX STAMP
Stamps all documents you scan
for direct sending or memory
sending.
Stamps only documents you
scan for direct sending.
TTI Selector
OFF
button.
Chapter 12
Advertisement
Table of Contents
