Selecting Run Mode - Toshiba TS3000 Series Instruction Manual

series Robot Controller
(d) File selection via data transmission.
A file can be selected by data transmission in either "EX. 232C" or "EX. ETHER" mode.
For details, see the Communication Manual.
When the execution file is selected, the following display appears on the screen.
Cautions
 In the external control mode, an execution file cannot be selected through the
teach pendant, using a command.
 The internal automatic operation is a function of the TS3000 robot controller.
9.3

Selecting Run Mode

Functional Explanation
Changes over the run mode of automatic operation.
Operating Procedure
(a) External control signal mode:
When the cycle operation mode signal is turned on, the cycle operation mode is
selected. When the same signal is turned off, the continuous operation mode takes
effect.
For the cycle operation mode signal, see the Interface Manual.
(b) Starting via data communication
Select a run mode via data communication when in the "EX. 232C" or "EX. ETHER"
mode.
For details, refer to the Communication Manual.
TP3000 OPERATOR S MANUAL
9-5
STE 85412