Attaching A Condenser; Preparation For Attaching A Condenser - Nikon ECLIPSE Ti2-U Instruction Manual

7.11

Attaching a Condenser

This section describes the procedures for mounting condenser modules, a condenser, and a condenser lens.
Components to be attached for each microscopy
Performing NAMC with DIC microscopy:
• Use a polarizer, a condenser module (slit diaphragm), and an objective that support NAMC.
• Attach an NAMC objective for and an NAMC condenser module, both of which must have the same
NAMC code.
Performing IMSI with DIC microscopy:
• Use a polarizer, an analyzer, a condenser module, an objective, and a DIC slider that support IMSI.
• Attach an IMSI objective and an IMSI condenser module, both of which must have the same IMSI
code.
Performing a Ph Microscopy:
• Use an objective suitable for Ph microscopy and a condenser module for Ph microscopy suitable for
the condenser used.
7.11.1

Preparation for Attaching a Condenser

1. Loosen the condenser clamp screw (hex
socket head cap screw) on the right side of
the condenser holder using a hexagonal
screwdriver.
(Tool: 2 mm hexagonal screwdriver, supplied with
the microscope main body)
2. Attach a condenser or a condenser turret to
the condenser mount.
For condenser:
ELWD condenser:
DF condenser:
High NA condenser: See §7.11.5.
See §7.11.2.
See §7.11.3.
See §7.11.4.
153
Chapter 7 Assembly of the Devices
Condenser mount
Condenser holder
Condenser clamp screw
(in the hole on the side)