Nikon ECLIPSE Ti2-U Instruction Manual page 160

Chapter 7 Assembly of the Devices
Using a TC-S-HM middle handle
Six M4 set screws are supplied with the middle handle. (Tool: 2 mm hexagonal screwdriver, supplied with the
microscope main body)
1. Remove each of the middle handle parts by
turning them, and divide them into three
parts.
2. Place the stage with its top surface facing
downward while making sure that the top
surface is not damaged.
3. Screw in part A to the handle mount while
firmly holding the handle mount by one
hand.
4. Firmly affix the attached part A using the
two M4 set screws.
Attach a set screw to the tip of the hexagonal
screwdriver and screw it into each hole (2 in
total) at the lower part of the side of part A to
affix it.
5. Cover part A with part B and screw it in.
When screwing in, use one hand to firmly hold
the root of the handle mount.
6. Firmly affix part B using two M4 set screws.
Affix a set screw to the tip of the hexagonal
screwdriver and screw it into each hole (2 in
total) at the lower part of the side of part B.
7. While using a hexagonal screwdriver to
keep part A from turning, screw in part C,
and then firmly affix it using set screws.
Notes on mounting
When screwing in part C, make sure to keep part
A from turning using a hexagonal screwdriver to
avoid co-rotation. If part C is screwed in while part
A is free to rotate, the rack of the stage might be
damaged.
1) Insert the hexagonal screwdriver into a hole
on the side of part B, and with the screwdriv-
er pressed in lightly, turn part A inside. When
the hexagonal screwdriver reaches the posi-
tion of the hole on part A, insert the screw-
driver further.
2) While keeping the hexagonal screwdriver
inserted into the hole, screw in part C to part
A.
3) Affix a set screw to the tip of the hexagonal
screwdriver and screw it into each hole (2 in
total) on the side of part C.
8. Mount the manual stage on the microscope
main body (See §7.7.1.)
Part A
5. Screw in part B.
3. Screw in part A.
Stage
Attaching parts A and B
7.-1) Insert a
hexagonal
screwdriver to
keep it from
turning.
Hole on part
Hole on part
Hexagonal screwdriver
Attaching part C
140
Part B Part C
6. Fix with set
screws (M4, x 2).
4. Fix with set
screws (M4, x 2).
Handle mount
7.-2) Screw in
part C.
7.-3) Fix with
set screws
(M4, x 2).