Switching The Condenser Module - Nikon ECLIPSE Ti2-U Instruction Manual

3.4.6

Switching the Condenser Module

Condenser turret (system condenser)
When switching the condenser module, manually
turn the turret ring to place the module into the
optical path.
 Operation:
Turret ring
Turn until it clicks into
position.
The address of the condenser turret in the optical
path can be checked by the position display on
the front surface of the turret.
Shutter addresses on the condenser turret
By attaching the light shielding plate module supplied with the condenser turret to the designated address,
it can be used as a condenser shutter.
HNA condenser slider
To switch the condenser module, move the HNA
condenser slider back and forth.
 Operation:
Slider
Push it in to the rear.
Pull it out to the front.
Condenser turret
The front or rear module
enters the optical path.
Condenser module
The DIC module
enters the optical path.
The Ph module
(or hollow) enters the
optical path.
Position display
Turret ring
(both sides)
Switching the module on the condenser turret
Slider in/out levers
(both sides)
Switching modules by the HNA condenser slider
45
Chapter 3 Usage of Components
Slider