Notes About This Documentation; Validity Of This Documentation; Copyright; Table 1: Variants - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
753-461 2AI Pt 100/RTD
1

Notes about this Documentation

Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1

Validity of this Documentation

This documentation is only applicable to the I/O module 753-461 (2AI Pt
100/RTD) and the variants listed in the table below.

Table 1: Variants

Item number/Variant
Pt-resistance sensors
753-461
Operating mode configurable with WAGO-I/O-CHECK
753-461/003-000
Documentation Validity for Variants
Unless otherwise indicated, the information given in this documentation applies
to listed variants.
The I/O module 753-461 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus coupler or
controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2

Copyright

This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
Notes about this Documentation
Designation
2AI Pt 100/RTD
2AI Pt100/free configurable
5
Manual
Version 1.3.1