Fitting The Lid; Building Under A Continuous Worktop; Preventing Heat Build-Up - Miele PG 8582 CD Operating Instructions Manual

Installation
Steam condenser
Protective foil/
Worktop
protector
Preventing heat
build-up
Securing to the
worktop
146

Fitting the lid

The lid must be screwed to the washer-disinfector. The side with the
screw threads on the underside goes to the front and the side with
the safety screw holders protruding downwards goes to the back.
Follow the fitting instructions supplied with the lid.
Place the lid on the washer-disinfector so that it is flush with the

machine.
Tighten the two securing screws on the back of the machine.

Open the door.

Remove the cover caps on the left and right and tighten the fixing

screws. Then replace the cover caps.

Building under a continuous worktop

To avoid steam damage to the worktop the protective foil supplied
(25 x 58 cm, self-adhesive) must be applied underneath the
worktop in the area of the steam condenser.
The protective foil supplied protects the worktop from damage
caused by steam when the door is opened. It should be positioned
underneath the worktop above the machine door.
During the drying phase, the hot exhaust air from the wash cabinet is
released into the surrounding environment through the steam
condenser at the rear of the machine. Sufficient ventilation must be
ensured to prevent heat build-up and excessive condensation.
Leave a minimum distance of 10 mm for air exchange between the

machine and the worktop.
If necessary ventilation grilles should be fitted in the side units.

To improve stability the machine must be secured to the worktop
after it has been aligned.
Open the door.
