Multi Mbms Communication Mode; System Turns On - Pylontech PowerCube-H1 Operation Manual

3.6.3.3 Multi MBMS Communication Mode

In some project it configures multi Energy Storage Systems. In
this case will have multi MBMS. The address of MBMS must follow
<MBMS's Address Configure Table>

3.6.4 System turns on

Double check all the power cables and communication cables. Make sure the voltage of the PCS
is same level with the battery system. Check all the power switch of every battery system is OFF.
Vérifiez deux fois tous les câbles d'alimentation et les câbles de communication. Assurez-vous que
la tension du PCS est identique à celle du système de batterie. Vérifiez que l'interrupteur de chaque
système de batterie soit éteint.
Warning: MBMS must be turned on after all battery strings self-check finish.
MBMS doit être activé une fois le contrôle automatique des chaî nes de batterie terminé.
Warning: The external switch or breaker between PCS and battery string must be off before the
battery system power on.
Un interrupteur ou disjoncteur externe entre le PC et la chaî ne de batterie doit
que le système de batterie ne soit alimenté.
System turns on step:
(1) Switch the external power or inverter/PCS on, to make sure all the power equipment can work
normally.
(2) Confirm the MBMS is
(3) Turn on all the BMS (Battery Control Modules) as follow step:
Turn on the 1 BMS (Battery Control Modules) of battery string:
st
The second BMS must be operated after the first battery string's self-check is successful.
From 1st BMS to the last BMS Then turn on the battery strings on one by one.
off.
27
ê
tre désactivé avant