Pylontech PowerCube-H1 Operation Manual page 16

Control Module (SC1000-100) Front Interface
Power Terminal +/-
To connect battery power cables in series.
Power Switch
Switch the battery system's (control module and high voltage DC power) ON/OFF.
Caution: When the breaker is tripped off because of over current or short circuit, must wait after
30min to turn on it again, otherwise may cause the breaker damage.
Attention : Lorsque le disjoncteur est déclenché en raison d'une surintensité ou d'un court-circuit, il
ne peut être rallumé qu'après avoir attendu plus de 30 minutes, sinon cela pourrait endommager
le disjoncteur.
External Power Terminal +/-
Connect battery system with Inverter.
Dry Contact Terminal
Dry Contact Terminal: provided 2 input and 4 output dry contact signal.
Out1 Stop Charge
Out2 Stop Discharge
Out3 Error
Out4 Current Limit
In1 Internal Using ONLY
In2 For wake up or
For Emergency Stop
signal**
Reset
Always close, when open shall stop charge.
Always close, when open shall stop discharge.
Always close, when open shall stop operation
Always close, when open shall limit current to ≤0.2C-rate
For wake up signal serial connection using ONLY.
Always close, when open will switch off the system.
12