WAGO-TO-PASS® 761
761-316 TO-PASS® Mobile, 4 AI, Web, MODBUS
7.5.2.1
Multiplex Settings
Select your TO-PASS
using the identifier. Select the Multiplex Settings option under Multiplex Input.
The buttons for enabling multiplex operation and the selection of the recipients of
the analog values to be transmitted are provided on the right side.
Figure 26: Configuring multiplex operation settings
Table 29: Configuring multiplex operation settings
Enable/Addresses
Multiplex
operation
Address
Analog value
Manual
Version 2.0.0
®
telecontrol module from the left side of the project tree
Click the button [Use] to enable/disable multiplex operation
for digital inputs DI1 ... DI4.
If a status combination of digital inputs DI1 ... DI4 is fulfilled
in multiplex operation for which a message text has been
defined, a corresponding message will then be sent (see
below).
Use this button to select the addresses to which the message
is to be transmitted when the corresponding status
combination of digital inputs DI1 ... DI4 is fulfilled.
Click the button [Internet] for applications with GPRS
transmission.
Use these buttons to select four analog values which can also
be transmitted with the message text when the corresponding
status combination of digital inputs DI1 ... DI4 is fulfilled.
Parameterizing
61