Setting The Sampling Rate; Previewing Data - Fourier TriLog User Manual

4. Tap OK to make the name change. If you are not sure how to enter
text, refer to your Palm Powered computer manual

3.Setting the Sampling Rate

The sampling rate specifies the number of samples per unit of time you wish to
collect (e.g.10 samples per second).
To set the sampling rate for the assigned sensor(s), from the Edit Trial Setup form:
1. Tap Set Rate
2. Pick the time unit (seconds, minutes or hours) from the Time unit
pick list in the Choose Sampling Rate dialog
3. Pick the number of samples per time unit from the Samples/time unit
pick list.
4. Tap OK
Note: The maximum sampling rate depends on the time unit and the
number of sensors connected. If you specify more than one
sensor, the same rate applies to both.

4.Previewing Data

When you complete your trial setup, you may wish to preview your data. In Preview
you can:
•
Ensure that your handheld computer, TriLog and sensors are properly
connected
•
Verify that a sensor is measuring what you intend it to measure
•
Verify that a sensor has reached a stable value
•
Adjust the y-axis scale to better suit your data
To preview data from one or more sensors, from the Trial Setup form:
Chapter 2 Working with Palm Handheld 25