Camber Mixing - RadioLink AT10II Instruction Manual

ADJUSTABILITY
• Rate: -100% to +100%, with a default of +30%
• Center position (CENTER): The operation reference point of flap can be offset. -100% to +100%,
with a default of 0%.
Note: When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please
set up after pressing DIAL for 1 second and canceling an alarm display.
Goals
Ex: Set the maximum
travel of 35% of the
total flap travel.

4.3.7 Camber Mixing:

This function adjusts the mixing rate of camber operation which operates the wing camber (ailerons
and flaps) in the negative and positive directions. The aileron, flap, and elevator rates can also be
adjusted independently and attitude changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. (PRE)
Note: Camber control is not assigned at initial.
ADJUSTABILITY:
Steps
Open the CAMBER FLAP
function.
Adjust the up/down trim
amount separately.(Ex: adjust
to 35%)
Or: adjust the center position
of flap servo
Close
Inputs
to BASIC . again to ADVANCE
to CAMBER-FLP,
to FLP
。
VR (A), to 35%，
VR (A), to 35%，
Repeat.
to CENTER
59
Radiolink Electronic Ltd
www.radiolink.com
。
, to desired point.