10G2X Module; 10G2X Leds - Extreme Networks BlackDiamond 8810 Hardware Installation Manual

BlackDiamond 10K Series I/O Modules

10G2X Module

Figure 44 shows the 10G2X module.
Figure 44: 10G2X module
The 10G6X module has two unpopulated XENPAK-based 10 Gigabit Ethernet ports.
If you have one MSM installed, all ports on the 10G2X module are switched through that MSM. If you
have two MSMs installed, the top port on the 10G2X module is switched through the MSM in slot A,
and the bottom port is switched through the MSM in slot B during normal operation.
The default configuration of the 10G2X module is as follows.
All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (for example, protocol type and VLANid).

10G2X LEDs

The 10G2X module has the following LEDs:
Module status
Port status
For information about the LEDs and their activity on the 10G2X module, see
page 93.
Extreme Networks Consolidated XOS Hardware Installation Guide
Module status LEDs
10 Gbs ports
ASP035
"I/O Module LEDs" on
92