10G2X Module; Xenpak Ports - Extreme Networks BlackDiamond 10808 Hardware Installation Manual

BlackDiamond 10808 Series Modules

10G2X Module

Figure 8 shows the 10G2X module.
Figure 8: 10G2X Module
Module status LEDs
10 Gbs ports
The 10G2X module has two unpopulated XENPAK-based 10 Gigabit Ethernet ports.
If you have one MSM installed, all ports on the 10G2X module are switched through that MSM. If you
have two MSMs installed, the top port on the 10G2X module is switched through the MSM in slot A,
and the bottom port is switched through the MSM in slot B during normal operation.
The default configuration of the 10G2X module is as follows. All ports:
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●

XENPAK Ports

The 10G2X module supports any of the following XENPAKs:
SR XENPAK
●
LR XENPAK
●
ER XENPAK
●
ZR XENPAK
●
LX4 XENPAK
●
LW XENPAK
●
NOTE
CX4 XENPAKs are also supported with Extreme Networks devices; contact your vendor to obtain these.
26
ASP035
BlackDiamond 10808 Switch Hardware Installation Guide